how to care for drums

Muslim Bayudi - How to care for drums
1.Select Drumhead / proper membrane
There are several types drumhead commonly used to maximize the sound of Snare Drum. To choose which head over kevlar material because it Snare Drum Pearl Championship Series is designed for high pressure. Preferably use of REMO Drumhead, and there are two types of Falams II and White / Blackmax. Each has a unique character, but should we return to the coach, the character of what it wants (Equipment Drum Band).

Head down to two types as well, Kevlar and Mylar. Kevlar is a type of drumhead woven from silk base material, while mylar drumhead is kind of a mixture of chemical-based plastics. Kevlar to further maximize Snappy snare sound and tuning are much higher. But basically mylar drumhead is sufficient (Drum Tool Band).

2. Installation Drumhead

The basic principle is expected of Snare Drum voice is high and tight head pressure so that the reflection of the stick can be more responsive. For the key point lies in the process of tightening the bolt (Drum Tool). Pressure each side of the bolt should be equal, the safest course is cross-tighten. To find out if enough pressure is equal to the beat in the area near the bolt, the sound should be the same. So also with the lower drumhead. Originally same pressure, the drumhead can be tightened as much as possible without any risk of rupture. Pressure above will definitely faster than the bottom, it's because the Kevlar material that is thicker at the top drumhead. View Marching Band and Marching Band Equipment

3. Tone Drumhead

Although the drumhead on the pressure harder but the tone should be half lower than head down (Drum Band). Standard tuning is C for drumhead over and C # to head down. Head down higher to speed up the response of Snappy snare it, so that it can offset the pressure on the tight head (Drum Marching Band).

4. Pressure Snappy Snare

To tighten each nylon snare, then the position off first. Then each of nylon snare tightened up and pitched sound stable. It would be better if each of nylon snare the same tone. Then the position of the on-the snare and position the form of nylon snare equally touching the head down. Do not let the pressure of different left and right so that no one nylon snare position tilted upward. After seeing nylon snare touching equally on the surface of the head, turn the knob again to memperkencang voltage Stainer Stainer nylon. Make sure every surface of nylon snare equally vibrating drumhead surface along the bottom (Drum Tool).

5. Addition Silencer

There are some people who feel the character of the snare drum is too wet, so adding tape or tape on snarenya nylon, to make a little crisp. Basically for Snare Drum Pearl Championship Series was not necessary, logically if nylon snarenya muted, meaning snarenya sound will be lost and it's not the snare drum lag (Drum Band) i. However, if it is needed, add one or two strips alone at opposite corners of a position on / off nylon snare, so it does not interfere with the work pedal on / off it.

Tweet